Beep Settings; Display Settings; Set Guiding Rate - iOptron CEM40 Instruction Manual

5.4.2. Beep Settings

The Hand Controller allows a user to turn off the beep partially, or even go to a silent mode. To
change this setting press "MENU =>Settings => Beep Settings",
Set Up Time and Site
Beep Settings

Display Settings

Set Guiding Rates
Set Tracking Rate
Set Parking Position
Meridian Treatment
Set Altitude Limit
Set Eyepiece Light
Select one of three available modes:

"Always On" – a beep will be heard on each button operation or mount movement;

"On but Keyboard" – a beep will be heard only when the mount is slewing to the object or there
is a warning message;

"Always Off" – all sounds will be turned off, including the SUN warning message.
5.4.3. Display Settings
Press "MENU =>Settings =>Set Display",
Set Up Time and Site
Beep Settings
Display Settings
Set Guiding Rates
Set Tracking Rate
Set Parking Position
Meridian Treatment
Set Altitude Limit
Set Eyepiece Light
Use the arrow keys to adjust LCD display contrast, LCD backlight intensity, and keypad's backlight
intensity.

5.4.4. Set Guiding Rate

Press MENU => "Settings" => "Set Guiding Rates",
Set Up Time and Site
Beep Settings
Display Settings
Set Guiding Rates
Set Tracking Rate
Set Parking Position
Meridian Treatment
Set Altitude Limit
This is an advanced function for autoguiding when a guiding camera is used either via an ST-4
guiding port or using the ASCOM protocol. Before autoguiding, align the polar axis carefully. Select an
appropriate guiding speed. The latest firmware allows you to set the R.A. and DEC guiding speed
differently. The R.A. guiding speed can be set between ±0.01X to ±0.90X sidereal rate. The DEC guiding
speed can be set between ±0.10X to ±0.99X sidereal rate. Follow the instructions of your autoguiding
software for detailed guiding operation.
27