iOptron CEM40 Instruction Manual page 19

Return the mount to Zero Position after balancing and engage gear switches.
STEP 8. Connect Cables
Plug in included 12V/5A DC power supply to the DC12V 5A socket, which is located at the end of
the RA axis.
Connect the Go2Nova
module into the iPORT with a coiled cable. When powering on, GPS ON sign should be displayed at the
upper right corner of the hand controller.
If you want to use the iPort for another accessory, such as wi-fi adapter (iStarFi #7434), or electronic
focuser (#8451/#8452), you may disconnect the GPS module after it picks up satellites signals and displays
GPS OK on hand controller. (It takes about 1 to 2 minutes in normal conditions).
Figure 23. Balance a mount
Figure 24. Power connection
®
Hand Controller to the HBX port on the mount main board. Plug GPS
Figure 25. Ports for cables
19