Set Beep - iOptron HAZ31 Instruction Manual

lacking internet, WiFi, or cell phone signals in rural areas; Commander Lite can always get GPS info from a
smartphone to the HAZ mount/hand controller, no dead corner. Please refer to iOptron Commander Lite for
more details (https://www.ioptron.com/v/ASCOM/iOptronCommanderLiteAppNote.pdf).
Figure 22. Sync Time and Site info from iOptron Commander Lite to the HAZ mount
Select N/S Hemisphere
The northern/southern hemisphere will be determined by your latitude coordinate.
Check Hand Controller Battery
The hand controller has a real time clock (RTC) which should display the correct time every time the
mount is turned on. If the time is incorrect, please check the battery inside the hand controller and
replace it if needed.
The other information, such as Long, Lat, UTC, DST, is stored inside the hand controller's memory
chip and will not be lost after mount power off. If you are not traveling to another observation site, they do
not need to be changed.

5.3.2. Set Beep

The Hand Controller allows a user to turn off the beep partially, or even go to a silent mode. To
change this setting press MENU => "Settings" => "Set Beep",
Set Up Time and Site
Set Beep
Set Display
Set Guiding Rate
Select one of three available modes:
"Always On" – a beep will be heard on each button operation or mount movement;
"On but Keyboard" – a beep will be heard only when the mount is slewing to the object or there is a
warning message;
"Always Off" – all sounds will be turned off, including the SUN warning message.
24