Appendix F. Iguider For Cem40G - iOptron CEM40 Instruction Manual

Appendix F. iGuider for CEM40G

CEM40G has a built-in iOptron iGuider
focal length guiding scope and a Windows based driverless guiding camera.
1. Focus adjuster locking screw (2mm hex), 2.Focus adjuster, 3.Lens cover
The iGuider only support ASCOM guiding (no ST-4 connection). Please install iGuider
ASCOM driver from iOptron website. PHD2 guiding software also has the camera included.
1. Connect iGuider to a PC
The iGuider guiding system is connected internally to the mount main USB port.
CEM40G is connected to the USB2.0 port
Connect the mount to a PC via a USB cable. Check your PC device list via Device
Manager. You should see an iOptron iGuider under the Camera.
2. Setup PHD2 Guiding
Download
https://openphdguiding.org/downloads/. Please select V2.6.7 or later version.
TM
guiding system. It includes a 30mm diameter and 120mm
on the rear end of mount RA axle
freeware PHD2 autoguiding
52
.
software from