Settings; Set Time And Site; Set Beep; Set Display - iOptron iEQ30 Pro Instruction Manual

5.4. Settings

5.4.1. Set Time and Site

Refer to 3.2.8.

5.4.2. Set Beep

The Hand Controller allows a user to turn off the beep partially, or even go to a silent mode. To
change this setting press "MENU =>Settings =>Set Beep",
Set Up Time and Site
Set Beep

Set Display

Set Guiding Rate

Set Tracking Rate
Set Parking Position
Meridian Treatment
Tracking Below Horizon
Select one of three available modes:
"Always On" – a beep will be heard on each button operation or mount movement;
"On but Keyboard" – a beep will be heard only when the mount is slewing to the object or there
is a warning message;
"Always Off" – all sounds will be turned off, including the SUN warning message.
5.4.3. Set Display
Press "MENU =>Settings =>Set Display",
Set Up Time and Site
Set Beep
Set Display
Set Guiding Rate
Set Tracking Rate
Set Parking Position
Meridian Treatment
Tracking Below Horizon
Use the arrow keys to adjust LCD display contrast, LCD backlight intensity, and keypad's
backlight intensity.
5.4.4. Set Guiding Rate
This is an advanced function for autoguiding when a guiding camera is utilized either via a
Guide Port or using the ASCOM protocol. Before autoguiding align the polar axis carefully. Select an
appropriate guiding speed. The suppositional guiding speed can be selected from ±0.10X to ±0.90X
sidereal rate. Follow the instructions of your autoguiding software for detailed operation.
The guide port wiring is shown in Figure 23, which has same pin-out as that from Celestron /
Starlight Xpress / Orion Mount / Orion Autoguider/ QHY5 autoguider.
26