Set Beep; Set Display; Set Tracking Rate - iOptron AZ Mount Pro Instruction Manual

The time and site information will be stored inside the hand controller's memory chip. If you are
not traveling to another observation site, they do not need to be changed.
Check Hand Controller Battery
The hand controller has a real time clock (RTC) which should display the correct time every time
the mount is turned on. If the time is incorrect, please check the battery inside the hand
controller and replace it if needed. The battery is a 3V, CR1220 button battery.

5.4.2. Set Beep

The Hand Controller allows a user to turn off the beep partially, or even go to a silent mode. To
change this setting press MENU => "Settings" => "Set Beep",
Set Time and Site
Set Beep

Set Display

Set Tracking Rate

HBX Heating ON/OFF
Wi-Fi Option
Language
Select one of three available modes:
"Always On" – a beep will be heard on each button operation or mount movement;
"On but Keyboard" – a beep will be heard only when the mount is slewing to the object or there
is a warning message;
"Always Off" – all sounds will be turned off, including the SUN warning message.
5.4.3. Set Display
Press MENU => "Settings" => "Set Display",
Set Time and Site
Set Beep
Set Display
Set Tracking Rate
HBX Heating ON/OFF
Wi-Fi Option
Language
Use the arrow keys to adjust LCD display contrast, LCD backlight intensity, and keypad's
backlight intensity.
5.4.4. Set Tracking Rate
You can set up the mount tracking rate by selecting "Set Tracking Rate".
Set Time and Site
Set Beep
Set Display
Set Tracking Rate
HBX Heating ON/OFF
Wi-Fi Option
Language
23