Maintenance - Ariens Sno-Thro Deluxe Track 24 Operator's Manual

SNOW REMOVAL
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperature before clearing
snow.
NOTE: Attachment clutch should be engaged
before wheel drive clutch when throwing
snow.
1. Select Speed Control position and
direction.
2. Engage Attachment Clutch - Right Hand
Lever.
3. Engage Traction Drive Clutch - Left
Hand Lever.
IMPORTANT: DO NOT overload unit capacity
by attempting to clear snow at too fast a rate.
Use slow speed to clear deep or hard packed
snow.
Tips for Operation
Snow is best removed as soon as possible
after snow fall.
To clear an area, run unit in an overlapping
series of paths. For large areas, start in the
middle and throw snow to each side, so snow
is not cleared more than once.
ALWAYS direct snow away from area to be
cleared and with direction of the wind.
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur and remove battery
(if equipped). Ensure unit is secure
and will not tip over during

maintenance.

1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Close fuel shut-off valve (see Fuel Shut-
Off Valve on page 17).
3. Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service.
TRAVELING
To travel from one work area to another:
1. Set Throttle to Slow or Part-Throttle
2. 921305, 306, 307: Press down on
3. Engage wheel or track drive clutch
TRANSPORT
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
MAINTENANCE
IMPORTANT: Ensure unit is secure and will
not tip over. Strap and clamp onto bench if
needed.
GB - 20
position.
handlebars enough to raise front of unit
slightly off surface.
921311, 312: Place the unit in the
transport position (see Track Angle on
page 17).
without engaging attachment drive
clutch.
Service Position
Figure 14
OS7121