Ariens Sno-Thro Deluxe Track 24 Operator's Manual page 17

Track Angle
(921311, 312)
(Figure 12)
The track angle can be adjusted to position
the auger housing for level clearing, deep
cutting or transport.
Squeeze the handlebar trigger and press
down on the handlebars to move the auger
housing into an up position. Release the
trigger to hold the position.
Lift up on the handlebars and squeeze and
release the handlebar trigger to move the
auger housing into a down position.
Figure 12
Normal
Transport
Deep Cutting
OS7111
GB - 17
FILLING FUEL TANK
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Fuel Shut-Off Valve
IMPORTANT: The fuel shut-off valve MUST
be in the closed position prior to transporting
the unit.
The fuel shut-off valve has two positions:
Open Position: Use this
position to run the unit.
Closed Position: Use
this position to service,
transport, or store the
unit.
Figure 13
To add fuel to fuel tank:
1. ALWAYS place unit in open or well-
ventilated area.
2. Stop engine and allow to cool.
3. Clean fuel cap and surrounding area to
prevent dirt from entering fuel tank.
4. Remove cap.
5. Fill fuel tank to within 1.2 cm below
bottom of filler neck with unleaded
gasoline.
NOTE: Refer to Engine Manual for proper
fuel type and tank capacity.
6. Replace fuel cap and tighten.
7. ALWAYS clean up any spilled fuel.
OS77280