Ariens Sno-Thro Deluxe Track 24 Operator's Manual page 24

4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
1
1. Adjusting Nuts
2. Cable Support Bracket
Figure 19
DISCHARGE CHUTE MANUAL
DEFLECTOR
(921305)
Deflector must stay in selected position while
blowing snow.
To adjust, loosen then retighten hardware to
desired deflection drag force (Figure 20).
Adjusting
Hardware
Figure 20
OS7175
2
Discharge Chute
Deflector
Discharge
Chute
OS7176
DISCHARGE CHUTE
If discharge chute does not stay in position
while operating, tighten nut on carriage bolt at
pivot point to increase tension on spring
(Figure 21).
1
2
OS7177
SPEED SELECTOR
ADJUSTMENT
To adjust (Figure 22):
1. Disconnect adjustment pivot pin from
speed selector lever by removing hair
pin.
2. Place the speed selector on the dash in
the fastest forward speed position.
3. Turn the speed selector lever straight
down towards the ground as far as it will
go.
4. Thread the adjustment pivot pin along
the shift rod until it aligns with the mating
hole on the speed selector lever. Insert
the pivot pin into hole.
5. Secure adjustment pivot pin with hairpin.
6. Make sure the speed selector shifts into
each speed position.
7. Check forward and reverse speeds:
a. Start unit.
b. Shift speed selector into the first
forward speed.
c. Engage the traction clutch. Unit
should move forward.
d. Stop unit.
GB - 24
2
1. Spring
2. Nut
Figure 21
1