Removing The Boss Card - Dell HHB006 Installation And Service Manual

Figure 39. Installing the M.2 BOSS module
Next steps
1. Install the air shroud.
2. Follow the procedure listed in

Removing the BOSS card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the M.2 BOSS
Steps
1. Using the Phillips #1 screwdriver, remove the screw on the M.2 BOSS module.
2. Pull the BOSS card out of the connector and lift the card away from the module.
After working inside your system
Safety instructions
Before working inside your system
module.
on page 47.
on page 46 section.
on page 46.
Installing and removing system components 79