Table of Contents
Advertisement
Installing the rSPI card
Prerequisites
Follow the safety guidelines listed in
CAUTION:
To prevent damage to the rSPI card, you must hold the card only by its edges.
Steps
1. Align the screw hole on the rSPI card with the standoff on the system board.
2. Using the Torx #8 screwdriver, replace the screw to secure the rSPI card to the system board.
Figure 59. Installing the rSPI card
Next steps
1.
Install the system
board.
2. Follow the procedure listed in
Safety instructions
on page 46.
After working inside your system
on page 47.
Installing and removing system components
101
Advertisement
Table of Contents
