Settings For Playback - Sony DSR-40 Operating Instructions Manual

Playback

Settings for Playback

Preparation on the player (this VCR)
Preparation on the recorder
18 GB
Chapter 2 Playback and Recording
1
Power on the video monitor, then set the monitor's input according to
the input signals from the recorder.
2
Set up the recorder.
For details, see "Preparation on the recorder" below.
3
Power on this unit by pressing the ON/STANDBY switch.
The ON/STANDBY lamp lights in green.
4
When you play back a tape recorded in 4-channel mode (Fs 32k), set
the AUDIO MONITOR selector to MIX (see page 13). Then select the
precise balance between the tracks with the AUDIO MIX BALANCE
in the menu (see page 53).
Notes
• With the DV connection, the playback VCR's AUDIO MONITOR
(sound selection) and AUDIO MIX BALANCE (audio balance
adjustment) do not function on the source audio output through the DV
jack.
• You cannot change the input signal selection during playback or playback
pause mode.
• Insert a tape for recording.
• Select the video and audio input signals to be recorded.
Note
Editing is not possible with a tape that is copyright protected.