Playback; Settings For Playback; Playback Operations - Sony HDV HVR-1500 Operating Instructions Manual

Playback

This section describes the settings and operations
necessary to perform playback on this unit.
For details of connections and settings when using this
unit as part of an editing system, see Chapter 5,
"Connections and Settings for Editing" (page 55).
For details of use for dubbing through the i.LINK
interface, see Chapter 6, "Using the i.LINK Connector for
Dubbing and TC Insert" (page 64).

Settings for Playback

2
HVR-1500 (this unit, player)
POWER
1
INPUT SELECT
i.LINK VIDEO CH1 1/2 CH2 3/4
OVER
REC/PB LEVEL
1 2 3 4
CH
MONITOR
LEVEL VARIABLE
SELECT
REC
PRESET
PB
PHONES CONTROL-S
REW
1
Power on this unit by pressing on the "(" side of the
POWER switch.
2
Power on the video monitor and set its switches as
shown below.
Switch
75 Ω termination switch
Video monitor
EJECT
LOCAL
9PIN
i.LINK
OVER
REPEAT 1080 525
HDV DVCAM
0
(DV)
-12
DISPLAY MENU ASSIGN RESET(NO)
-20
-30
-40
-60
TC
1 2 TC VITC 44.1K
CH
COUNTER PRESET SET(YES)
01:23:45:15
EDIT MODE SELECT
REC INHI
PLAY F FWD STOP REC
A B
Setting
ON (or attach a 75 Ω
terminator.)

Playback Operations

POWER
INPUT SELECT
i.LINK VIDEO CH1 1/2 CH2 3/4
OVER OVER
0
REC/PB LEVEL
-12
1 2 3 4
-20
-30
-40
-60
1 2
CH CH
MONITOR
LEVEL VARIABLE
SELECT EDIT MODE
REC INHI
REC
PRESET
PB
PHONES CONTROL-S
REW PLAY
2
Note
When controlling this unit from a device connected to the
REMOTE connector or the HDV/DV connector of this
unit, set the remote control switch of this unit to 9PIN or
i.LINK. When not, set the switch to LOCAL.
1
Insert a cassette.
For details of cassette insertion, see page 40, and for
usable cassette types, see page 39.
The cassette is automatically drawn into the unit and
the STOP button lights. A few seconds later, if the
STOP under the AUTO EE SELECT menu item (see
page 74) is set to PB, a still image will appear on the
monitor screen.
2
Press the PLAY button.
This starts the playback operation. When the tape is
played back all the way to the end, the unit
automatically rewinds it and then stops.
Indicators lit when a cassette is loaded
Indicator
CL
To stop playback:
Press the STOP button.
The unit enters stop mode, and will automatically switch to
standby off mode for tape protection.
To adjust the audio playback level:
For digital or analog audio output:
Set the VARIABLE switch on the front panel to PB and
use the REC/PB LEVEL control knobs for each channel.
1
Remote control switch
EJECT
LOCAL
9PIN
i.LINK
REPEAT 1080 525
HDV DVCAM
(DV)
DISPLAY MENU ASSIGN RESET(NO)
TC
TC VITC 44.1K
COUNTER PRESET SET(YES)
01:23:45:15
SELECT
F FWD STOP REC
A B
It means:
The loaded cassette contains a
cassette memory.
There is ClipLink log data
stored in the cassette memory
on the loaded cassette.
Playback
45