Playback; Settings For Playback - Sony DSR-1500A Operating Instructions Manual

Playback

Settings for Playback

34
Playback
This section describes the settings and operations necessary to perform playback
on this unit. The same settings and operations apply whether you are using the
unit as part of an editing system, for dubbing, or as a stand-alone player VCR.
For the necessary connections for playback and the settings not covered in this
section, see Chapter 5 "Connections and Settings" (page 79).
Player (DSR-1500A/1500AP)
1
1
Power on this unit by pressing on the
2
Power on the video monitor and set its switches as shown below.
Switch
75 Ω termination switch
Input switch
Video monitor
2
dB OVER dB OVER INPUT CL REC INHI
U-BIT SERVO
0 0 VIDEO AUDIO
V:SDTI COMPOSITE
CH-1 1/2 CH-2 3/4 TC COUNTER NO EDIT REPEAT
SDTI S VIDEO ANALOG ANALOG
-12 -12
i.LINK Y-R,B AES/EBU AES/EBU
-20 -20
SDI SG SDI SG SDI SG
OUTPUT
-30 -30
VIDEO AUDIO
-40 -40
SDI COMPOSITE CH 1/2 HOURS MINUTES SECONDS FRAMES
-60 -60
SDTI S VIDEO CH 3/4 PB F REC MODE VITC REMOTE
S
CH- 1 3 CH- 2 4 9P i.LINK
Y-R,B 48K 44.1K 32K 2CH 4CH EDIT MODE
REW PLAY F FWD STOP REC
side of the POWER switch.
Setting
ON (or attach a 75 Ω terminator.)
Set according to the type of input signal from this
unit.