Emulation Probe - Fujitsu F2MC-8L Series Getting Started

Following settings of the jumper plugs and the DIP-switch can be selected:
J1: Jumper setting for Emulator/EPROM
Take also care of setting SW1-3 to the right mode!
J2: Jumper setting for reset button
Take also care of setting SW1-4 to the right mode!
SW1: DIP-switch for clock and mode settings
SW1-1 & SW1-2: ON
SW1-1 & SW1-2: OFF
Take also care of setting jumper J1 & J2 to the right mode!
For power supply you have to apply a voltage of 2.7 volts to 5.5 volts (typical 5 volts)
depending on the operation conditions like frequency, functions etc. to the on-board DC
connector or via the 40-pin connector CN2.

2.3 Emulation Probe

To connect the evaluation board to the user target system the emulation probe with SDIP
socket and flat cable can be used. On emulation probe and evaluation board there are
prepared 40-pin connectors (CN2 on evaluation board) for this issue.
MCU-AN-300000-E-V11
MB89201 Series – Getting Started
Chapter 2 Hardware Tools
Setting
open
close
Setting
open
close
Setting
SW1-3: ON
SW1-3: OFF
SW1-4: ON
SW1-4: OFF
Description
Connect MCU to EPROM
Connect MCU to Emulator
Description
Reset button disabled
Reset button enabled
Description
X0, X1 connected to CN2
X0, X1 not connected to CN2
EPROM mode
Emulator mode
Reset button enabled
Reset button disabled
- 8 - © Fujitsu Microelectronics Europe GmbH