Setting The Speaker Setup Manually - Sherwood NewCastle R-671 Operating Instructions Manual

SETTING THE SPEAKER SETUP MANUALLY

Note: When the SPEAKER button is set to off or the EXTERNAL IN is selected as an input source, the speaker setup
procedure cannot be performed.
Before setting the speaker setup
• Press the POWER switch to enter the standby mode and then turn the power on.
When selecting each setting mode,
1
• Each time the SPEAKER SETUP button is
pressed, the speaker setting mode changes in
succession and is displayed for several seconds
as follows.
• When the speaker setting mode disappears, press
the SPEAKER SETUP button repeatedly to select
the desired mode.
• When selecting the subwoofer,
"SUB-W Y"
• When selecting the front speaker size,
"FRONT L"
• When selecting the center speaker size,
"CENTER L"
• When selecting the surround speaker size,
"SURR L "
• When selecting the surround back speaker size,
"SURR-B L"
When adjusting the selected mode
2
to the desired setting,
• Each time the ADJUST UP(▲/›) or DOWN(▼/‹)
button is pressed, one of the settings is selected
and displayed for several seconds as follows.
• When the subwoofer is set to "N", the front speaker
is automatically set to "L".
• You can select one of 2 different speaker settings.
• You can select one of 3 different speaker settings.
(L: Large, S: Small, N: None)
• You can select one of 3 different speaker settings.
• You can select one of 3 different speaker settings.
19
Y(es) N(one)
L S
(L: Large, S: Small)