Sherwood NewCastle R-671 Operating Instructions Manual page 36

Select the desired preset number
3
(1~30) and press the MEMORY/ENTER
button.
• The station has now been stored in the memory.
• A stored frequency is erased from the memory
by storing another frequency in its place.
• If "MEM" goes off, start again from the above
step ②.
Tuning to preset stations
After selecting the tuner as an input
1
source, select the preset tuning mode.
• Then "PRESET" lights up.
Listening to FM stereo broadcasts
• While listening to FM broadcasts.
• Each time this button is pressed, the FM mode
changes as follows;
• When FM stereo broadcasts are poor because
of weak broadcast signals, select the FM mono
mode to reduce the noise, then FM broadcasts
are reproduced in monaural sound.
Repeat the above steps ① to ③ to
4
memorize other stations.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is
turned off, are memorized.
• INPUT SELECTOR settings
• Surround mode settings
• Preset stations,etc.
Select the desired preset number.
2
• When pressing the PRESET +/- buttons on the
remote control, you need not select the preset
tuning mode on step ①.
Scanning preset stations in sequence
• The receiver will start scanning the stations in the
preset sequence and each station is received for 5
seconds.
• At the desired station, press this button again to
stop scanning.
35