Sherwood NewCastle R-671 Operating Instructions Manual page 23

Specify the setting condition.
4
When specifying the number of speakers installed.
When specifying the subwoofer or the crossover frequency.
Start the auto speaker setup procedure.
5
Notes:
• Because the test tones are very loud, ensure
there are no infants or small children in the
room.
• For best results, ensure the room is as quiet as
possible during the auto speaker setup
procedure.
If there is too much ambient noise, the results
may not be satisfactory.
• Each time this button is pressed, the speaker layout
changes as follows:
• Each time the ADJUST UP(▲) or CURSOR RIGHT(▶)
button is pressed, the subwoofer changes as follows:
S No display
(Subwoofer: Yes) (None)
• Each time the ADJUST DOWN(▼) or CURSOR
LEFT(◀) button is pressed, the crossover
frequency("CUT") changes within the range of 40~130
Hz in 10 Hz intervals.
• In case that the subwoofer setting is
"S"(Subwoofer:Yes), if it is possible to adjust the
volume and crossover frequency on your subwoofer,
set the volume to about medium level (or slightly less),
and set the crossover frequency to the maximum.
• Loud test tones are output from each speaker.
• To stop the auto speaker setup procedure, press the
(MEMORY/) ENTER button.
To retry the procedure, press the (MEMORY/)
ENTER button again.
•After the auto speaker setup procedure has been
completed, "SET MEMO" will be displayed.
• If ">ERROR<" is displayed, there may be a problem
with the speaker or microphone connection.
While displaying ">ERROR<", to retry the procedure,
press the ADJUST UP(▲) or CURSOR RIGHT(▶)
button and to exit from the procedure, press the
ADJUST DOWN(▼) or CURSOR LEFT(◀) button.
• If retrying the procedure does not fix the problem, turn
off the power and check the speaker or microphone
connections.
22