Sherwood NewCastle R-671 Operating Instructions Manual page 33

At each channel, adjust the level as
2
desired until the sound level of each
speaker is heard to be equally loud.
• You can select the desired channel and adjust its
level with repeating the steps ① and ② in
"Adjusting the current channel level" procedure.
Adjusting the current channel level
• After adjusting each channel level with test tone, adjust the channel levels either according to the
program sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into
user's memory("USER"), not into preset memory("REF. 1", "REF. 2").
Press the CHANNEL SELECTOR button.
1
• Depending on the speaker setting and surround mode, etc., some channels cannot be selected.
• When the SPEAKER button is set to off, only the front L/R channel can be selected.
Adjust the level of the selected channel as
2
desired.
Repeat the above steps ① and ② to adjust each channel level.
3
Cancel the test tone function.
3
• Each time this button is pressed, "REF. 1" (or
"USER") is displayed and the corresponding
channel is selected as follows:
< >: Possible only when the digital signals from Dolby Digital or DTS
program sources that include LFE signal are input.
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the range
of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the
setting as necessary.
• If the channel display disappears, start from the
step ① again.
32