Table of Contents
Advertisement
Address related terms
(m) Indoor unit address ♦:
This is an ID individually assigned to each indoor unit.
(n) Remote controller address:
This is an ID individually assigned separately from the
indoor unit address to indoor units which form an R.C.
Group.
2 Password confi guration
This unit can set the following 2 kinds of passwords:
(a) Password
This is a password for administrator. Password is re-
quested by the setting which requires management. For
a description of password setting and change, refer to
[3 SETTING] →[3-9 Initial Setting]→[3-9-5 Password
Setting] .
(b) Installer password
This password is requested for important settings at
installation.
NOTE
If you forget your password, contact your local dealer.
3 Name of parts
(a)
(b)
(c)
(d)
(a) Touch screen
• When the screen is touched or the On/Off button is
pressed while backlight is set to Enable, backlight
lights. Backlight goes off 30 or 60 seconds after the
last operation. When backlight is set to Disable, it does
not light. For a description of backlight setting, refer to
[3 SETTING]→[3-8 Preference]→[3-8-2 Backlight Set-
ting].
• Lightly touch the touch screen with your fi nger tips. A
commercially available stylus pen can also be used.
If pushed with too much force or operated with a
rod, pencil, or ballpoint pen, etc., the screen may be
scratched or damaged.
• Do not touch 2 or more places simultaneously. Correct
operation cannot be performed.
• When cleaning the touch screen, setting child safety
lock prevents erroneous operation. (Refer to [1 MONI-
TOR] → [1-1 Monitor] → [1-1-3 Child Lock].) When
cleaning, do not use detergent or alcohol, paint thin-
ner, etc. It will cause accidents or loss of appearance.
(b) Power indicator lamp
Lights while the indoor unit is operating. Blinks when an
error is detected.
(c) On/Off button
(d) Room temperature sensor (inside)
Setting is necessary to use this sensor. Refer to [3
SETTING] → [3-9 Initial Setting] → [3-9-4 R.C. Sensor
Setting].
En-4
Advertisement
Table of Contents
