Lincoln Electric BURNY KALIBURN Spirit II 275 User Manual page 103

Spirit II User's Manual
Impulse Start Console (ISC)
1. Open the cover (door) of the impulse start console and verify that all leads and
hoses are tightened securely. Only tighten the fittings enough to make a water
or gas seal. The fittings are subject to damage if over tightened.
Work Ground
1. Verify that the work ground lead is securely fastened to the star ground on the
cutting table, and that the connection point is free from corrosion. Use a wire brush
to clean the connection point if necessary.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Section 6: Maintenance &Troubleshooting
6-3