Sharp UX-510 Operation Manual page 13

3
Take the new film out of its package,
and insert two of the gears provided with
the fax into the ends of the spool with
film. Make sure that the two tabs on the
gears fit properly into the slots in the
ends of the spool.
Do not yet remove the band which
holds the spools together.
4
Hold the empty spool so that the end
with only one slot is on the left, and
lower the spools into the front of the
printing compartment. The gears in the
ends of the spool with film should fit into
the slots on each side of the printing com-
partment.
5
Cut the band which holds the spools to-
gether with scissors, and remove it. Insert
the remaining gear into the right end of
the empty spool and the flange into the
left end of the empty spool. Make sure
the tabs on the gear and the flange fit into
the slots in the ends of the spool (the gear
has two tabs and the flange has one tab).
Chapter 1
2 tabs
1 tab
Flange
Installation
2 tabs
Gear
3