Sleep Timer - Sharp SD-HX500 Operation Manual

Sleep timer

SD-HX500
ENGLISH
The unit turns off at a specified time when listening to a disc or the radio.
1
During playback, set the MODE 1/MODE 2 switch to MODE 2 and
press the TIMER/SLEEP button.
2
Within 10 seconds, press the
select "SLEEP SET", and press the ENTER
button.
3
Press the or
(Maximum: 2 hours - Minimum: 1 minute)
" 2 hours - 5 minutes
" 5 minutes - 1 minute
4
Press the ENTER button.
" The unit will enter the power stand-by mode auto-
matically after the preset time has elapsed.
" The volume will be turned down 1 minute before the sleep operation finishes,
and then you cannot change the volume.
E-53
or button to
button to select the time.
5-minute intervals
1-minute intervals
To confirm the remaining sleep time:
1 While "SLEEP" appears, set the MODE 1/MODE 2 switch to MODE 2 and press
the TIMER/SLEEP button.
2 Within 10 seconds, press the or
" The remaining sleep time is displayed for about 10 seconds.
" You can change the remaining sleep time while it is displayed by pressing the
ENTER button (steps 3 - 4).
To cancel the sleep operation:
Press the ON/STAND-BY button while "SLEEP" is indicated.
To cancel the sleep operation without setting the unit to the stand-by mode, proceed
as follows.
1 Set the MODE 1/MODE 2 switch to MODE 2 and press
the TIMER/SLEEP button.
2 Within 10 seconds, press the or
"SLEEP OFF".
3 Within 10 seconds, press the ENTER button.
("SLEEP" goes out.)
! To use timer and sleep operation together
For example, you can fall asleep to the radio, and wake up to CD.
1 Set the sleep time (steps 1 - 4).
2 Set the timer playback (steps 1 - 8, page 51).
Make sure timer playback does not start while sleep timer is active.
The unit enters into the power stand-by mode after the time set for sleep timer, and
turns on at the start time of timer playback.
1
Sleep timer setting
2
Timer playback setting
1 minute - 2 hours
1minute - 2hours
Sleep operation will
Sleep operation
automatically stop.
starts.
button to select "SLEEP".
Remaining sleep time
button to select
Start time Finish time
Desired time
Timer playback Timer playback will
starts. automatically stop.