Changing The Default Settings Of The Amplifier - Sharp SD-HX500 Operation Manual

Changing the default settings of the amplifier

Change settings according to the connected speakers.
Speaker size setting (See pages 46, 47.)
Speaker delay setting (See page 47.)
Speaker level setting (See page 48.)
Test tone (See page 48.)
Changing crossover frequency (See page 49.)
Example:
If the right surround speaker is 10 feet (3.3 m) away from the listening position,
change settings as shown below (adjust the SR).
CT
FR
FL
SW
SL SR
Default setting: 6 feet (2 m)
1 In "Speaker delay setting", set the right surround speaker (SR) to 10 feet (3.3 m).
2 In "Speaker level setting", slightly increase the level of the right surround speaker
as it is a little farther than others (see page 48).
3 In "Test tone", check the sound from each speaker (see page 48).
Notes:
" The subwoofer setting applies to a subwoofer connected to SUBWOOFER PRE
OUT.
" You cannot change the default settings while playing SACD/DVD-Audio discs.
CT
FR
FL
SW
10 feet
(3.3 m)
SL
SR
If you press during the
operation, you can go
back one step.
! Speaker size setting
You can change the sizes of the front speakers, center speaker, and surround speak-
ers, or turn on or off the center speaker, surround speakers, or subwoofer.
1
Set the MODE 1/MODE 2 switch to MODE 2 and press the AMP SET
UP button.
2
Within 10 seconds, press the
select "SP SIZE", and press the ENTER but-
ton.
3
Within 10 seconds, press the
select the desired speaker.
The indicators of selected speakers flash.
or button to
or button to
Continued to the next page
SD-HX500
ENGLISH
E-46