System Installation - Sharp SD-HX500 Operation Manual

System installation

SD-HX500
ENGLISH
! Placing the speaker system
The best surround effect will be achieved by placing each speaker at the same
distance from the listening position.
It is recommended to arrange the speakers as shown below.
speaker (left)
Subwoofer
Surround
speaker (left)
Note:
The default distance is set to 6 feet (2 m). If speakers cannot be placed at equal dis-
tances, refer to "Speaker delay setting" (see page 47).
Installation image:
E-11
Center
Front
Front
speaker
speaker (right)
Surround
speaker (right)
Notes:
" Place the TV halfway between the front speakers.
" It is recommended that the center speaker be placed near the television.
" Place the surround speakers at a position just above the height of your ears.
" The subwoofer vibrates while reproducing bass. Place it on a stable, sturdy sur-
face.
" The subwoofer reproduces bass. Place it anywhere you like.
Default setting:
Front speaker (left)
6 feet (2 m)
! Cooling fan
This unit is fitted with a cooling fan at the rear for improved cooling. Do not cover the
opening in this section with any obstacles.
Caution:
" The unit will get warm while being used. Do not touch the warm areas of the unit
for prolonged periods to avoid damage to you.
" This unit contains an automatic protection circuit, which protects the unit from
being damaged. All speaker outputs are muted when this circuit is activated.
Should the unit stop operating, first check the speaker terminals for shorted wires,
then press the ON/STAND-BY button to turn on the unit.
Front speaker (right)
Center speaker
Cooling fan