Sharp SD-HX500 Operation Manual page 63

! Mounting the wall bracket on the wall
VESA (*) compliant fittings (commercially available) can be attached to the wall
bracket.
Fittings are not supplied, but can be purchased.
Note:
(*) VESA (Video Electronics Standards Association) is an organization to promote
the standardization of digital imaging device for PCs.
Types of fittings:
Fittings must satisfy the following.
" Compatible with the VESA standard.
" Have a gap of 3.973" (100 mm) 3.973" (100 mm) between the screw holes on the
section to be attached.
" Sturdy and stable to prevent fall or breakage.
3.973" (100 mm)
How to attach fittings
" There are four VESA (*) screw holes on the wall bracket. You can use commer-
cially available fittings for mounting.
" Follow the method recommended by the bracket manufacturer.
Warning:
" Install brackets properly following the operation manual. Improper installation may
cause the main unit to fall leading to injury or breakage.
" To ensure a proper installation, contact your dealer or installer.
" During installation, be careful not to pinch your fingers.
" The wall should be strong enough to support the weight of the main unit. (Install
on a reinforced part.)
" Do not impose an extra load on fittings. It may cause the main unit to fall leading to
injury or breakage.
" Do not modify or change the wall bracket. It may cause the main unit to fall leading
to injury or breakage.
Caution:
" Do not block the ventilation opening of the main unit with a tablecloth, etc. Heat
may be kept inside causing fire.
" Select a mounting position carefully to avoid injury by hitting head.
" Never step on or hang from the main unit. Pay special attention to children. It may
cause injury or breakage to the main unit.
" Check the wall strength. SHARP is not liable for accidents caused by insuffi-
cient strength of the wall or improper mounting.
" Improper mounting may cause the main unit to fall. If you need assistance,
contact your dealer or installer.
3.973"
(100 mm)
SD-HX500
ENGLISH
E-58