Sleep Operation - Sharp FV-DB2E Operation Manual

Sleep operation

FV-DB2E
When the set time elapses, the unit turns off automatically.
Before setting sleep:
For the sleep operation, connect the AC adaptor to the unit. If
batteries are the only power source, setting is not possible
(see page 6).
1
Press the CLOCK button repeatedly to
select "Set sleep".
2
Within 30 seconds, move the operation
lever toward TUNING UP or TUNING
DOWN to select the desired sleep time.
! Select set time from 1 - 120 minutes by
the minute.
! Move the operation lever once to change the time by 1
minute. Hold it to change continuously.
3
Within 30 seconds, press the ENTER
button.
! "SLEEP" appears in the display of the unit.
! Remaining time is displayed during the sleep operation.
! The volume gradually decreases for the last 1 minute.
4
The unit will enter the power stand-by mode automatically
after the preset time has elapsed.
20
To cancel the sleep setting:
Press the ON/STAND-BY button whilst "SLEEP" is indicated.
To cancel the sleep operation without setting the unit to the stand-by
mode, press the CLOCK button until "Sleep off ok?" appears on the
display, then press the ENTER button.
Note:
The kitchen timer starts at a set time even if the sleep operation is
set for the same time. The sleep operation starts after the kitchen
timer ends.
" To use alarm and sleep operation together
...
1 2 119 120
For example, you can fall asleep listening to the radio and wake up
to alarm in the next morning.
1 Set the sleep operation (steps 1 - 3).
2 Set the alarm (steps 1 - 6, page 18).
The unit enters the power stand-by mode after the time is set for
sleep operation, and turns on at the start time of the alarm.
1 Sleep setting
2
Alarm setting
1 minute - 2 hours
Sleep
operation
starts.
05/4/21 FVDB2E_UK.fm
Start time
Sleep operation Alarm starts.
will automatically
stop.
TINSEA048SJZZ