Lift Up Prevented - Lift Down Then Set Outriggers; Lift Up Prevented - Tilted - JLG T350 Troubleshooting Manual

2.112 LIFT UP PREVENTED - LIFT DOWN THEN SET OUTRIGGERS

Distress Lamp: 2
The ground module senses the controls in the lift up position, but the platform is stowed and the outriggers are not com-
pletely set or stowed. Lift up is prevented until all outriggers are either set or stowed. While outriggers are stowed, functions
should only be used for aligning the boom for transport.
Functions Disabled: Lift Up
Step Pretest Instructions
2.112.1
2.112.2
2.112.3

2.113 LIFT UP PREVENTED - TILTED

Distress Lamp: 2
Lift Up is being attempted while the Platform is Stowed, all four Outriggers are Set, but the vehicle is Tilted.
The ground module senses the controls in the lift up position, the platform is stowed and the outriggers are all set, but the
vehicle is tilted. Lift up is prevented until all outriggers are either set or stowed. While outriggers are stowed, functions should
only be used for aligning the boom for transport.
Functions Disabled: Lift Up
Step Pretest Instructions
2.113.1
2.113.2
3121203
SECTION 2 - TROUBLESHOOTING BY FAULT MESSAGES
ADE Code: 2-5
Test
Are all outriggers set?
Are all outriggers stowed?
Are you attempting to align
the boom for transport?
ADE Code: 2-5
Test
Is the machine tilted more
than 2 degrees?
Analyzer DIAGNOSTICS ->
SYSTEM -> TILT >= 2 DEG
(platform tilt LED illumi-
nated)
T350 T500J
Result
Yes
No
Yes
No
Yes
No
Result
Yes
No
Yes
No
Corrective Action
See 3.11 Outrigger Switches - All Set
Go to step 2.112.2
See 3.12 Outrigger Switches - All
Stowed
Go to step 2.112.3
Stow all outriggers and try again
Set all outriggers and try again
Corrective Action
Level the machine and try again
Go to step 2.113.2
See 3.16 Tilt Sensor
Possible Causes: 4.1.10
2-93