JLG T350 Troubleshooting Manual page 184

4. Slide the wedge lock into the housing until it is flush with the housing (See Figure 7-10.).
Disassembly
1. Insert a 4.8 mm (3/16") wide screwdriver blade between the mating seal and one of the red wedge lock tabs.
2. Pry open the wedge lock to the open position.
3. While rotating the wire back and forth over a half turn (1/4 turn in each direction), gently pull the wire until the contact is
removed.
NOTE: The wedge lock should never be removed from the housing for insertion or removal of the contacts.
Wedge Lock
The wedge lock has slotted openings in the forward, or mating end. These slots accommodate circuit testing in the field, by
using a flat probe such as a pocket knife. DO NOT use a sharp point such as an ice pick.
3121203
Figure 7-11. Connector Disassembly
Figure 7-10. Connector Assembly Figure 4
T350 T500J
SECTION 7 - ELECTRICAL REFERENCE
7-184