JLG T350 Troubleshooting Manual page 136

SECTION 5 - SYSTEM TEST MESSAGES
5.24 CHECKING INPUTS
System test status message indicating that it has begun testing digital inputs to the module being tested (ground or plat-
form).
5.25 CHOKE CL
ENGINE POWERED MACHINES ONLY
System test response indicating that the ground choke switch has been closed when a different switch was expected. Make
sure the correct switch is being activated or check the switch wiring.
5.26 CHOKE HOLD
ENGINE POWERED MACHINES ONLY
System test prompt indicating that it is currently testing this circuit.
5.27 CHOKE HOLD SOLENOID OPEN CIRCUIT
ENGINE POWERED MACHINES ONLY
The system test detected an open circuit in the choke hold circuit.
See 2.14 Choke Hold Solenoid Open Circuit
5.28 CHOKE HOLD SOLENOID SHORT TO BATTERY
ENGINE POWERED MACHINES ONLY
The system test detected a short to battery in the choke hold circuit.
See 2.15 Choke Hold Solenoid Short To Battery
5.29 CHOKE HOLD SOLENOID SHORT TO GROUND
ENGINE POWERED MACHINES ONLY
The system test detected a short to ground in the choke hold circuit.
See 2.16 Choke Hold Solenoid Short To Ground
5.30 CHOKE PULL
ENGINE POWERED MACHINES ONLY
System test prompt indicating that it is currently testing this circuit.
5.31 CHOKE PULL RELAY OPEN CIRCUIT
ENGINE POWERED MACHINES ONLY
The system test detected an open circuit in the choke pull circuit.
See 2.17 Choke Pull Relay Open Circuit
5-136 T350 T500J 3121203