Installation - ADC H4TU-C-388-L1 User Manual

Installation

I
NSTALLATION
Upon receipt of the equipment, inspect the contents for signs of damage. If the equipment has
been damaged in transit, immediately report the extent of damage to the transportation
company and to ADC.
H4TU-C-388
When installing an H4TU-C in a chassis, be sure to wear an antistatic wrist strap. Avoid touching
components on the circuit board.
To comply with the intrabuilding wiring requirements of GR-1089 CORE, Section 4.5.9, the
shields of the ABAM-type cables that connect the H4TU-C DSX-1 output ports to the
cross-connect panel must be grounded at both ends.
1 Align the H4TU-C with the enclosure slot guide, then push the unit back until it touches the backplane
card-edge connector.
2 Press down on the H4TU-C front panel to properly seat it.
8
Figure 2. Installing the H4TU-C-388 List 1 into a Shelf
September 12, 2003
LTPH-UM-1122-02, Issue 2
CO Shelf
H4TU-C-388 List 1