Installation; Power-Up Sequence - ADC H2TU-C-202 List 4E Quick Installation

I
NSTALLATION
To ensure proper installation of the H2TU-C, align the unit with the enclosure slot
guides and slide it in until it touches the backplane card-edge connector.
To comply with the intrabuilding wiring requirements of
GR-1089 CORE, Section 4.5.9, the shields of the
ABAM-type cables that connect the H2TU-C-202 List 4E
DSX-1 output ports to the cross-connect panel must be
grounded at both ends.
P
OWER
When the H2TU-C powers up, the four status LEDs illuminate and report status
messages.
If the H2TU-C is able to communicate with the H2TU-R, the following occurs:
1 The LOOP Status LED flashes green while acquiring each device in the system,
and turns a steady green when the entire system is operating without any alarms.
(The DS1 signal must be present.)
2 If any alarm conditions exist after the system powers up, these are reported on the
appropriate status LED (see the descriptions of the four status LEDs on the
front-panel illustration inside).
P
ROVISIONING
After installing the H2TU-C, perform these basic provisioning tasks by accessing the
HiGain HDSL2 logon screen. Refer to the onscreen Help menu for navigational aids.
1 Connect a maintenance terminal to the craft port (see front-panel illustration
inside) then press
2 Select the Config menu, Date and Time, then type the date and time.
3 Select the Inventory menu, then type in the unit ID numbers.
4 Change the settings of any system parameters, if necessary, by selecting the
Config menu, Standard Options or ADC Options.
5 Once the H2TU-C is successfully installed and provisioned, access the Monitor,
Performance or Event Log menus to clear the Performance, Alarm History or
Event Log screens, or use Master Clear in the Config menu.
- S
UP EQUENCE
CTRL R
+ to refresh the logon screen, if necessary.
Þ
Continued