Table of Contents
Advertisement
RE3 UHF Wireless
7.3.12
Adjusting receiver output level
Setting the receiver output level through menu item 7, RX Output Level assigns either mic
level, or line level to the receiver XLR and ¼" TS output jacks. This is an important step in
ensuring the signal level leaving the receiver is appropriate for the destination circuit of either
a microphone preamp, or a line in preamp.
1.
2.
3.
4.
5.
7.3.13
Turning antenna power on and off
The receiver antenna jacks can supply 12vDC booster feed to power the optional RFAMP
booster, or ALPA active antenna.
1.
Electro-Voice
Press the ▼ button to scroll down to RX Output Level from the main menu. Select by
pressing SET to enter the RX Output Level screen.
M
4. Squelch
E
5. Mic Config
N
6. Volume
U
7. RX Output Level
The display shows the current volume setting of either MIC or LINE.
Output Level
LINE
MIC
To select desired level, pressing the ▲ button toggles from MIC to LINE, and the ▼ toggles
from LINE to MIC.
Output Level
LINE
MIC
Press SET to save changes and return to the main menu.
M
4. Squelch
E
5. Mic Config
N
6. Volume
U
7. RX Output Level
Either scroll ▼ to Exit and press SET, or briefly press SYNC on the receiver front panel to
return to the home screen.
M
9. Keylock
E
a. Display Option
N
b. Reset
U
c. Exit
From the main menu, press ▼ button to scroll to Antenna Power.
M
5. Mic Config
E
6. Volume
N
7. RX Output Level
U
8. Antenna Power
User Manual
RE3-RX receiver | en
35
02-2023 | 05 | F.01U.362.808
Advertisement
Table of Contents
