Table of Contents
Advertisement
RE3 UHF Wireless
ID
g
8.3
Installing batteries
–
–
–
–
–
8.4
RE3-HHT setup menu
Editing any of the following parameters locally on the transmitter is possible. These edits will
override the settings synchronized from the mated receiver. Additionally, any parameter value
changes made locally on the transmitter may be overwritten the next time the transmitter is
synced to the mated receiver if those parameters are selected in the receiver's sync
configuration.
NOTE: No local edits will be possible if the transmitter is in Keylock mode (lock icon
displayed). See unlocking instructions below.
NOTE: Press and hold SET for three seconds to enter parameter edit mode. The frequency in
millions will begin flashing. Once in parameter edit mode, pressing SET multiple times will
advance through the adjustable parameters one parameter per press. The press and hold of
SET to enter parameter edit mode counts as the first SET button press.
Function
Frequency
setup
581.725
Electro-Voice
Item
Keylock icon
While gripping the transmitter handle/battery cover section (item 2 shown above) with
one hand, grip the control section (item 3 shown above) with the other hand. Using a left-
hand twist, unscrew the control section until it is free from the handle. Slide the control
section away from the handle until the battery compartment (item 6 shown above) is fully
exposed.
Gently rotate the hinged protective battery cover to expose the battery chamber. Note
the battery polarity markings (+ and -) on the protective cover. Both positive (+) contacts
are adjacent to the control section male threads.
Install two fresh, high quality AA alkaline batteries (or fully charged AA size NiMH
rechargeable cells) paying close attention to match the polarity markings (+ and -) on
each battery to the polarity markings (+ and -) of the battery contacts as shown on the
battery cover.
Once both new batteries are properly installed, rotate the hinged protective battery cover
downward until the cover is in contact with the batteries.
Applying the same gripping technique used while opening the transmitter to expose the
batteries, gently slide the battery compartment back inside the handle until the control
section can move no further. Using a right hand twist, screw the control section onto the
handle section until it is tightly threaded on. Be careful not to overtighten the threads.
# of SET button
presses
1 Millions
2 Thousands
MHz
To save changes:
Press SET while thousands is flashing; SAVE is displayed / returns to
home screen.
Description, usage and notes
Indicates transmitter is in lock mode.
▲ Increases frequency in increments of 1 MHz per press.
▼ Decreases frequency in increments of 1 MHz per press.
▲ Increases frequency in increments of 1 kHz per press.
▼ Decreases frequency in increments of 1 kHz per press.
User Manual
RE3-HHT handheld transmitter | en
Result
02-2023 | 05 | F.01U.362.808
43
Advertisement
Table of Contents
