Table of Contents
Advertisement
CME1202R & CME1402R
FOR THE INSTALLER: Location & Assembly
Location:
After uncrating and inspection, the unit is ready for
installation. It is important that the machine be
installed in a location where it has enough space
around it to be accessible for service. Try to avoid
hot, dirty and crowded locations. Be sure that the
location for the machine is within the
environmental limitations.
ICE MACHINE AND BIN ASSEMBLY
Storage Bin:
Tip the storage bin on its back, using parts of the
carton to protect the exterior finish. Install the legs
packed with the BH900. If stacking use a heavy
duty leg kit (KLP6).
1. Arrange for proper electric, water and drain. See
instructions for the plumber and for the electrician.
2. After mounting the legs position the ice storage
bin in the selected location:
Note: Allow enough space to the left and back to
service the machine. Do NOT push the bin into
position, instead, lift it there. Pushing a bin may
damage the legs and leg mounts.
Level the bin in both the front to rear and side to
side directions by adjusting the leg levelers.
SHIPPING
3. Inspect the bin top mounting gasket. It must be
BRACKETS
flat, with no gaps, to provide a good water seal
when the cuber is installed on top of the bin.
Ice Maker:
Install the modular cuber on top of the bin using
care to be sure a good seal is made between the
two cabinets. Use of a mechanical lift is
recommended. Align the holes in the bottom rear
of the cabinet to mate with the two mounting holes
on the top rear of the bin.
Use bolts and straps found on the back of the ice
machine to secure the ice machine to the bin.
When alignment and leveling are completed,
tighten the bolts to secure the mounting straps.
Remove the front panel, and remove the
evaporator shipping brackets and hardware.
Remote Condenser:
A new condenser coil designed for the machine's
capacity MUST be used. Because of the possibility
of mineral oil contamination, coils and line sets
that had been connected to R-12, R-502 or R-22
units MAY NOT BE CONNECTED TO THIS
SYSTEM. Doing so voids the refrigeration system
warranty.
June 1996
Page 5
Advertisement
Table of Contents
