Table of Contents
Advertisement
FOR THE INSTALLER
Location
This ice system is designed to be installed indoors,
in a controlled environment.
Minimum
0
Air Temp
50
F.
0
Water Temp
40
F.
Water Pressure
20 psi
Voltage
104
Operating the machine oustide of the above
limitations, or outdoors, is potentially damaging to
the machine; also it is misuse of the machine
which may void the warranty.
Service Limitations
Do not install in a location where the top of the
machine is within 6" of a fixed ceiling. Air cooled
models require a minimum of 6 inches to the left
and right of the machine for air circulation. It is
important that the machine be installed in a
location where it has enough space above and
behind it for service.
After uncrating and inspection, the unit is ready for
installation.
Machine Stand Installation
Tip the stand on it's back and install the legs,
return the stand to the upright position. Adjust leg
levelers so that the stand does not "rock".
Counter Top or Machine Stand Installation
The base of the icemaker-dispenser must be
sealed to the object it rests upon. Food grade
silastic sealant such as Scotsman part number
19-0529-01 is recommended.
Place a bead of the sealant on the machine stand
or counter top to match the outside edge of the
cabinet base and sink.
The icemaker-dispenser is heavy: use of a
mechanical hoist is recommended to lift it to the
height required to install it.
The DMS machine stand has holes in the top that
match up with threaded holes in the base of the
machine. Secure the machine stand to the base
with 4 5/16" bolts.
In both counter top and machine stand
installations, wipe off and neatly smooth any
excess sealant. Level the machine stand and
cabinet.
Maximum
Unpack and install the sink brackets. Fit the sink
0
100
F.
assembly onto the two sink brackets, and press
0
100
F.
onto the bead of sealant. Wipe off and neatly
80 psi
smooth any excess sealant from under the sink
126
edge. Connect the sink drain to the dispenser
drain system.
SEAL
ICEMAKER-
DISPENSER TO
THE COUNTER
TOP OR
MACHINE STAND
January, 1989
Page 3
ND750
Advertisement
Table of Contents
