Table of Contents
Advertisement
CMS1202R
FOR THE INSTALLER: Location & Assembly
Location:
After uncrating and inspection, the unit is ready for
installation. It is important that the machine be
installed in a location where it has enough space
around it to be accessible for service. Try to avoid
hot, dirty and crowded locations. Be sure that the
location for the machine is within the
envrionmental limitations.
Storage Bin:
ICE MACHINE AND BIN ASSEMBLY
Tip the storage bin on its back, using parts of the
carton to protect the exterior finish. Install the legs,
use a heavy duty leg kit if stacking two ice
machines on one bin.
1. Arrange for proper electric, water and drain.
See instructions for the plumber and for the
electrician.
2. After mounting the legs, position the ice storage
bin in the selected location:
Note: Allow enough space to the left and back to
service the machine. Do NOT push the bin into
postion, instead, lift it there. Pushing a bin may
damage the legs and leg mounts.
Level the bin in both the front to rear and side to
SHIPPING
side directions by adjusting the leg levelers.
BRACKETS
3. Inspect the bin top mounting gasket which
should be flat, with no wrinkles, to provide a good
water seal when the cuber is installed on top of the
bin.
Ice Maker:
Install the modular cuber on top of the bin using
care to be sure a good seal is made between the
two cabinets. Use of a mechancial lift is
recommended. Align the holes in the bottom rear
of the cabinet to mate with the two mounting holes
on the top rear of the bin.
Use bolts and straps found on the back of the ice
machine to secure the ice machine to the bin.
When alignment and leveling are completed,
tighten the bolts to secure the mounting straps.
Remove the front panel, and remove the
evaporator shipping brackets and hardware.
September 1993
Page 3
Advertisement
Table of Contents
