Table of Contents
Advertisement
Drive System
Maintenance
Checking the Seat Belt
Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper
operation of retractor and buckle. Replace before
operating if damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep
the roll bar in the fully raised locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
Check that both the mounting hardware and the knobs
are in good working condition. Make sure that the
knobs are fully engaged with the roll bar in the raised
position. The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to get both
knobs fully engaged
(Figure
63).
1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position
Adjusting the Tracking
1.
Disengage the blade-control switch (PTO).
2.
Drive to an open, flat area, and move the
motion-control levers to the N
position.
3.
Move the throttle midway between F
S
.
LOW
4.
Move both motion-control levers forward until
they both hit the stops in the T-slot.
5.
Check which way the machine tracks.
6.
If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until
the machine tracks straight
50
Figure 63
3. Roll bar in the upright
position
4. Roll bar in the folded
position
-
EUTRAL
LOCK
AST
(Figure
64).
g008943
and
Advertisement
Table of Contents
