Table of Contents
Advertisement
Note:
In most conditions, the back blade tip
should be adjusted 6.4 mm (1/4 inch) higher
than the front.
14.
Torque the 2 bolts to 37 to 45 N∙m (27 to 33 ft-lb).
15.
On both sides of the deck, measure from the
level surface to the back tip of the blade (postion
B) as shown in
Figure
Note:
The measurement should read 8.3 cm
(3-1/4 inches)
16.
Fine tune the screw adjuster by turning it to get
8.3 mm (3-1/4 inches) height
To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
17.
Measure until all 4 sides are the correct height.
18.
Tighten all of the nuts on the deck-lift-arm
assemblies.
19.
Lower the discharge chute.
91.
(Figure
92).
Servicing the Cutting
Blades
To ensure a superior quality of cut, keep the blades
sharp. For convenient sharpening and replacement,
you may want to keep extra blades on hand.
Blade Safety
A worn or damaged blade can break, and a piece of
the blade could be thrown toward you or bystanders,
resulting in serious personal injury or death. Trying to
repair a damaged blade may result in discontinued
safety certification of the product.
•
Inspect the blades periodically for wear or damage.
•
Use care when checking the blades. Wrap the
blades or wear gloves, and use caution when
servicing the blades. Only replace or sharpen the
blades; never straighten or weld them.
•
On multi-bladed machines, take care as rotating 1
blade can cause other blades to rotate.
Before Inspecting or Servicing the
Blades
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
66
Advertisement
Table of Contents
