Servicing The Spark Plug - Toro 75967 Operator's Manual

Figure 53
Note:
Ensure that the oil-filter gasket touches
the engine, and then the oil filter an extra 3/4
turn.
3. Fill the crankcase with the proper type of new
oil; refer to Changing the Engine Oil (page

Servicing the Spark Plug

Service Interval: Every 100 hours
Make sure the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug(s) and a gapping tool/feeler gauge to
g029644
check and adjust the air gap. Install a new spark
plug(s) if necessary.
Type : NGK ®
Air Gap: 0.75 mm (0.03 inch)
Removing the Spark Plug
1. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
2. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
3. Remove the left hand hydraulic-unit shroud in
the order listed in
Note:
This gives you access to the front spark
plug.
g027477
43).
44
BPR5ES or equivalent
Figure 54.
-
EUTRAL LOCK