Kohler ECV940 Service Manual page 143

A
D
Electronic Throttle
A
Body (ETB)
C Breather Hose
2. Slide clamp and disconnect breather hose from ETB.
3. Disconnect vent hose from fi tting on ETB.
A
Electronic Throttle
A
Body (ETB)
4. Lift ETB with O-ring off studs in intake manifold.
5. Reverse procedure to reassemble.
62 690 05 Rev. H
B
C
B Vent Hose Fitting
D Clamp
B
B Stud
KohlerEngines.com
Disassembly/Inspection and Service
A
B
C
D
A TMAP Screw
C Injector Screw
Remove Fuel Injectors
1. Disconnect electrical connector.
2. Remove screw for each injector and pull injector out
of intake manifold.
3. When removed, pull metal retaining clip connecting
fuel injector to fuel injector cap. There may be some
fuel left in line. Any spilled fuel must be cleaned up
immediately.
4. Reverse procedure to install. Torque fuel injector cap
screws to 7.3 N·m (65 in. lb.).
Remove Temperature/Manifold Absolute Pressure
(TMAP) Sensor
1. With a screwdriver, slide locking tab on electrical
connector.
2. Carefully slide lock tab outward. Press down on lock
tab to release, then separate connectors.
3. Remove screw and pull TMAP sensor out of intake
manifold.
4. Reverse procedure to install. Torque screw to 7.3
N·m (65 in. lb.).
C
B TMAP
High Pressure Fuel
D
Line Assembly
143