Kyocera PE-MF2 Service Manual page 162

4. Appendix: SP Mode Tables
Fax Maintenance
Overseas Comm
Mode Settings
4
Dial Pulse Setting
Tone Signal Settings
44
This sets the machine to ignore a DIS signal sent from the
Overseas Comm
called station once in a sending operation.
Mode
[Off (Default)/ Ignore DIS Once]
If this setting is set to "On", the machine detects the CNG
signal after the line is connected. If it is set to "Off", the
Minimum Time
machine detects the CNG signal as long as the line is
Length
connected.
[100 Ms/ 200 Ms/ 300 Ms/ 400 Ms (Default)]
This sets the number of pulses that are generated during
dialing.
• N: Dialing '0' generates 10 pulses --- Dialing '9'
Dial Pulse Type
• N+1: Dialing '0' generates 1 pulses --- Dialing '9'
• 10-N: Dialing '0' generates 10 pulses --- Dialing '9'
Tone Signal
Sets the tone signal transmission time length
Transmission Time
[100 ms (Default)]
Length
Sets the minimum pause during tone dialing
Minimum Pause In
Tone Dialing
[100 ms (Default)/ 150 ms/ 200 ms]
Attenuator For
Sets the attenuator for pseudo ringback tone to the line
Pseudo Ring
Backtone To the
[0 to 15 / 10 (Default)/ 1 dB/step]
Line
Sets the transmission level of DTMF tones.
DTMF Level
[-12 dBu / -11 dBu/ -10 dBu/ -8 dBu/ -6 dBu]
Sets the level difference between high band frequency
signals and low band frequency signals when sending
DTMF Delta
DTMF tones.
[2 dBu/ 3 dBu]
generates 9 pulses.
generates 10 pulses.
generates 1 pulse.