Kyocera PE-MF2 Service Manual page 107

Message
Net Connection : FAIL(X)*1
Net Server : Connecting...
Net Upload : End of data
USB Upload : End of data
Cause/ Solutions
The IP address specified for either the machine or your computer is
invalid.
• Check that both IP addresses are valid.
The [F/W Update (USB)] or [F/W Update (NET)] button was
clicked when the update was already in progress.
• Clicking the [F/W Update (USB)] or [F/W Update (NET)]
button during the update process does not interfere with any
ongoing update.
• Ignore this error message and complete the update using the
procedure shown in this manual.
The machine is turned off or an error has occurred.
• Turn off the power, turn it back on, and then perform the update
again.
• If this message reappears after you turn the power back on,
see "Error and Status Messages on the Screen" in the User
Guide.
The machine is being operated through the operation panel.
• Cancel any operations being performed through the
operation panel.
• Put the machine into standby mode, and then perform the
update again.
Your computer is searching the network for the machine.
• Wait a while until the machine is found.
Firmware has been transferred to the machine successfully.
• Follow the instructions in this manual to complete the update.
Firmware has been transferred to the machine successfully.
• Follow the instructions in this manual to complete the update.
Firmware Updating
5
105