Table of Contents
Advertisement
12.13
Adjusting the chain tension
Warning
Danger of accidents Incorrect chain tension damages components and results in accidents.
If the chain is tensioned too much, the chain, engine sprocket, rear sprocket, transmission and rear
wheel bearings wear more quickly. Some components may break if overloaded.
If the chain is too loose, the chain may fall off the engine sprocket or the rear sprocket. As a result, the
rear wheel locks or the engine will be damaged.
–
Check the chain tension regularly.
–
Set the chain tension in accordance with the specification.
Main work
–
Shift the transmission into neutral.
–
In the area after the chain sliding guard, press the chain
upward toward the link fork and measure chain tension
Info
Top chain section
Chain wear is not always even, so you should repeat
this measurement at different chain positions.
M00714-10
Chain tension
»
If the chain tension does not meet the specification:
–
Adjust the chain tension. (
–
Remove the rear of the motorcycle from the lifting gear.
(
p. 54)
Preparatory work
–
Raise the motorcycle with the rear lifting gear. (
–
Check the chain tension. (
Main work
–
1
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
and right.
Guideline
Chain tension
Turn the adjusting screws
the markings on the left and right chain adjusters
the same position relative to the reference marks
rear wheel is then correctly aligned.
Info
The top chain section must be taut.
Chain wear is not always even, so you should check the
setting at different chain positions.
–
Tighten nuts
F00745-10
SERVICE WORK ON THE CHASSIS 12
B
must be taut.
5 ... 7 mm (0.2 ... 0.28 in)
p. 59)
p. 58)
.
2
.
5 ... 7 mm (0.2 ... 0.28 in)
3
on the left and right so that
2
.
A
.
p. 54)
3
left
4
are in
A
. The
59
Advertisement
Table of Contents
