K Mode Sol Error - Xerox Phaser 6125 Service Manual

Error Messages and Codes

K Mode Sol Error

3-80
K Mode Solenoid (Color Mode Switching Solenoid) error is detected.
Applicable Chain Link
042-372: K Mode Solenoid Error
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Feed Drive Assembly (Drive Assy
PH), PL7.1.4
MCU Board, PL8.2.13
Troubleshooting Procedure Table
Step Actions and Questions
1 Reseat the Imaging Unit.
Does the error still occur when the
power is turned OFF and ON?
2 Perform the K Mode Solenoid test
(page 4-29):
Test
During this check, close the Front
Cover.
Does the solenoid click when the K
Mode Solenoid check is performed?
Check the connection between the
3
MCU Board and K Mode Solenoid.
Is P/J24 connected securely?
4 Does the error still occur when the
power is turned OFF and ON?
Check the power to the K Mode
5
Solenoid
Disconnect J24 from the MCU Board.
Is the voltage across P24-1pin <=>
ground on the MCU Board, about +24
VDC when the Interlock Switch (HARN
ASSY INTERLOCK) is pushed?
Service Mode > Motor
> K Mode Solenoid.
Phaser 6125/6130 Color Laser Printer Service Manual
Wiring and Plug/Jack Map References
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Drive" on page 10-20
Yes No
Go to step 2. Complete
Go to step 7. Go to step 3.
Go to step 5. Reconnect the
connector P/J24
correctly, then
go to step 4.
Go to step 5. Complete
Go to step 6. Replace the
MCU Board
(page 8-59).