Xerox Phaser 6125 Service Manual page 291

Phaser 6125/6130 Color Laser Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
Open and close the Front Cover.
3
Does the Front Cover latch closed
properly?
Is the image printed correctly?
4
Reseat the Imaging Unit.
5
Is the image printed correctly?
Reseat the Fuser.
6
Warning: Start the operation after the
Fuser has cooled down.
Is the image printed correctly?
7 Open and close the Front Cover to
reseat the Transfer Unit.
Is the image printed correctly?
Is the paper damaged when fed from
8
the Manual Feed Slot?
Check the setting of the Manual Feed
9
Slot side guides and reset the side
guides if needed.
Is the image printed correctly?
Inspect the paper path.
10
Is there any contamination on the
paper path?
11 Is the image printed correctly?
12 Reseat the Paper Tray.
Is the image printed correctly?
Reset the Paper Tray side guides.
13
Is the image printed correctly?
Replace the paper in the Paper Tray
14
with new paper.
Is the image printed correctly?
Inspect the paper path.
15
Is there any contamination on the
paper path?
Is the image printed correctly?
16
17 Reseat the Separator Roller Assembly.
Is the image printed correctly?
Replace the Separator Roller
18
Assembly (page 8-7).
Is the image printed correctly?
Print-Quality Troubleshooting
Yes No
Complete Replace any
defective parts,
then go to step
4.
Complete Go to step 5.
Complete Go to step 6.
Complete Go to step 7.
Complete Go to step 8.
Go to step 9. Go to step 12.
Complete Go to step 10.
Clean the paper Go to step 12.
path (refer to
"Cleaning" on
page 7-2), then
go to step 11.
Complete Go to step 12.
Complete Go to step 13.
Complete Go to step 14.
Complete Go to step 15.
Clean the paper Go to step 17.
path (refer to
"Cleaning" on
page 7-2), then
go to step 16.
Complete Go to step 17.
Complete Go to step 18.
Complete Go to step 19.
5-55