Preparation; During Operation - Stiga XQ 130 HD V 302 Operator's Manual

(Translation of the Original Instructions)
and unstable ground.
In the event of changes in ownership or
loan of the machine, make sure the fu-
ture user reads the instructions for use
provided in this manual.
Never carry children or other passen-
gers on the machine: they might fall off
and be seriously injured or inhibit safe
use of the machine.
The operator of a machine must care-
fully follow the driving instructions, par-
ticularly:
a. the need for care and concentration when
using machines;
b. that control of a machine sliding on a slope
will not be regained by the application of the
brake. The main cause behind a loss of ma-
chine control are:
• insufficient wheel grip;
• being driven too fast;
• inadequate braking;
• the type of machine is unsuitable for its
task;
• lack of awareness of the effect of ground
conditions, especially slopes;
• Incorrect use of the machine as a towing
vehicle;
The machine is equipped with a series
of safety microswitches and devices
which must never be removed, altered
or tampered with. Removing these de-
vices invalidates the warranty and the
manufacturer declines any responsi-
bility. Always check the safety devices
work before using the machine.
3.2

PREPARATION

• When using the machine always wear sturdy,
slip-resistant footwear and long trousers.
• Never activate the machine when barefoot or
wearing open-toe sandals.
• Do not wear chains, bracelets, cumbersome
clothing with strings or ties.
• Tie back long hair. Always wear hearing pro-
tectors.
• Thoroughly inspect the area where the
equipment is to be used and remove all objects
which may be thrown by the machine (stones,
ENGLISH
sticks, metal wire, bones, etc.)
CAUTION: DANGER! The fuel is highly
flammable.
a. store fuel in containers specifically
b. refuel using a funnel and outdoors
c. Add fuel before starting the engine.
d. If fuel is spilled, do not attempt to
e. Always replace caps of fuel tanks and
Replace faulty silencers.
Before using, always carry out a visual
inspection, particularly of the cutting
device, seeing that the screws and cut-
ting devices are not worn or damaged.
Replace a worn or damaged cutter bla-
de and screws as a set to preserve ba-
lance.
Any repair shall be performed by an au-
thorized service centre.
Check the condition of the battery at
frequent intervals. Replace if damages
to the casing, cover or terminals are
found.
3.3

DURING OPERATION

Never start the engine in a confined
area where hazardous carbon monoxi-
de gases can build up.
All starting operations have to be ef-
fected in an open or well ventilated
area!
Always remember that exhaust gases
are toxic!
Mow only in daylight or with good artifi-
cial light in good visibility conditions.
Keep persons, children and animals
away from the working area.
designed for this purpose;
only. Do not smoke while refuelling or
whenever handling the fuel;
Never remove the cap of the fuel tank
or add fuel while the engine is run-
ning or when the engine is hot;
start the engine but move the ma-
chine away from the area of spillage
and avoid creating any source of igni-
tion until the fuel has evaporated and
the fumes dispersed;
container securely.
EN
7