Table of Contents
Advertisement
I
WARNING: For models with a slideout front facing dinette seat,
confirm that the tie down strap is installed correctly prior to travel.
BOOTH DINETTE TO BED CONVERSION
1. Remove the table top and cushions. Place them to the side.
2. Remove the table legs from the floor brackets and place them in one of the storage
compartments of the dinette seats. Place the storage cover back on the dinette seat.
3. Place the table top across the middle from one dinette seat to the other resting on
the front edge bracket. For comfort, make sure the table top is level with the top of
the dinette bench.
4. Position the dinette bench cushions in place across the benches and the table top.
To convert back to the booth dinette, reverse the procedures above.
J-STEEL SOFA TO BED CONVERSION
1. Lift up on the sofa seat and pull toward the center of the unit.
2. As you pull up, the back of the sofa will fall down and lay out flat to create a bed.
3. To convert back into a sofa, again lift up on the front edge and push toward the
unit wall.
4. As you do this, the sofa back will lift into an upright position.
HIDE-A-BED (OPTION)
1. Remove the cushions and place them to the side of the sofa.
2. Pull up, and out, on the handle located in the middle of the hide-a-bed. The middle
support leg will fold down to rest on the floor.
3. Using the end support leg, pull the end of the bed out to set on the floor.
4. Fold the mattress out to cover the end of the frame.
To put the hide-a-bed away, reverse the above steps. Make sure all bedding is removed
before storing the hide-a-bed. The hide-a-bed must be returned to the sofa position before
moving the slideout in to the travel position.
Caution: To eliminate damage to the arm cushions, make sure they are folded out or
lifted up when setting up or putting away the hide-a-bed.
SOFA/RECLINER FOOTREST OPERATION
1. Make sure cushion is clear of the footrest opening.
2. Place heels over the edge of the footrest and pull towards you to release the safety
lock.
3. Push down – do not force.
AWNING SET UP
Your RV may be equipped with awnings for the slideout, windows, and over the entrance
area. Provided with your unit are instructions from the manufacturer which supply the
operation and maintenance instructions for your awnings. If you have questions, consult
with your independent, authorized dealer, review the materials from the awning
manufacturer and/or visit their website at www.carefreeofcolorado.com.
Granite Ridge/Greyhawk/Escapade Type C Motorhome
Setting Up Camp...
37
Advertisement
Table of Contents
