Fuji Xerox DocuPrint P285 dw Online User's Manual page 168

LED Indication
Related Information
• Troubleshooting
• Replace Supplies
• Replace the Drum Unit
Status Monitor Cause
Out of Memory The machine's memory is
full.
Size Error DX The paper size specified in
the printer driver is not
(For automatic 2-
available for automatic 2-
sided printing
sided printing.
models)
The paper in the tray is not
the correct size and is not
available for automatic 2-
sided printing.
Size Mismatch The paper in the tray is not
the correct size.
Manual Feed Manual was selected as the
paper source in the printer
driver, but there is no paper
in the manual feed slot.
No Paper The machine is out of paper,
or paper is not loaded
correctly in the paper tray.
Toner Ended It is time to replace the toner
(Continue mode) cartridge.
Self-Diagnostic The temperature of the fusing
unit does not rise to a
specified temperature within
the specified time.
The fusing unit is too hot.
Print Unable The machine has a
mechanical problem.
Action
Reduce the print resolution.
Press Go. Choose a paper size
which is supported by the duplex
tray.
Paper size available for
automatic 2-sided printing is A4.
Load the correct size of paper in
the tray and set the tray for that
paper size.
Paper size available for
automatic 2-sided printing is A4.
Load the correct size of paper in
the tray and set the size of paper
to the tray.
Place paper in the manual feed
slot.
• Refill paper in the paper tray.
Make sure the paper guides
are set to the correct size.
• If paper is in the tray, remove
it and load it again. Make sure
the paper guides are set to
the correct size.
Replace the toner cartridge with a
new one.
Press and hold to turn the
machine off, wait a few seconds,
and then turn it on again. Leave
the machine idle for 15 minutes
with the power on.
• Press and hold to turn
the machine off, wait a few
minutes, and then turn it on
again.
• If the problem continues,
contact Fuji Xerox customer
service.
164