Table Of Contents - Agilent Technologies 54610B User's And Service Manual

Contents
1 The Oscilloscope at a Glance
To connect a signal to the oscilloscope 1-5
To display a signal automatically 1-7
To set up the vertical window 1-8
To set up the time base 1-10
To trigger the oscilloscope 1-12
To use roll mode 1-15
2 Operating Your Oscilloscope
To use delayed sweep 2-3
To use storage oscilloscope operation 2-6
To capture a single event 2-8
To capture glitches or narrow pulses 2-10
To trigger on a complex waveform 2-12
To make frequency measurements automatically 2-14
To make time measurements automatically 2-16
To make voltage measurements automatically 2-19
To make cursor measurements 2-23
To remove cabling errors from time interval measurements 2-27
To make setup and hold time measurements 2-28
To view asynchronous noise on a signal 2-29
To reduce the random noise on a signal 2-31
To analyze video waveforms 2-34
To save or recall traces 2-38
To save or recall front-panel setups 2-39
To use the XY display mode 2-40
3 Service
To return the oscilloscope to Agilent Techologies 3-4
Verifying Oscilloscope Performance 3-5
To check the output of the
To verify voltage measurement accuracy 3-7
3-6
DC CALIBRATOR
Contents-1